The clearances between the rocker arms and valves are adjusted on a cold engine, with the cylinder head fastening nuts and the nuts fastening the racks of the rocker arm axles are tightened to the required torque
We remove the tips of the spark plugs together with the high-voltage wires, the ignition coils (you can only disconnect the connectors by leaving them on the valve cover), the throttle cable and, having disconnected the wires from the sensors of the lubrication and cooling systems, remove the wiring harness from the brackets of the head cover .
The head of the block can be removed with the receiver and exhaust manifold
Installation of injection pump, injectors, high and low pressure pipes D-245
The engine has two hydraulic tensioners of the same design - for the upper and lower chain
You will need: a hex wrench “6”, heads “12”, “13”, “14”, a small chisel, a hammer
Drain the cooling system
The ZMZ-4062 engine does not have the usual idle system, like in a carburetor.
