The gaps between the rocker arms and valves are adjusted on a cold engine, with the cylinder head fastening nuts and the nuts fastening the racks of the rocker arm axles are tightened to the required torque

You will need: a hex wrench “6”, heads “12”, “13”, “14”, a small chisel, a hammer

Drain the cooling system

A non-contact ignition system of the DLI type is installed on cars, which provides an increase in the range of setting the ignition timing and voltage of the ignition distributor while reducing electrical interference.

The front wheel drives are removed for replacement if damaged or to replace the hinges and their covers

The vehicle must be parked on a flat, level surface.

The car uses DC electrical equipment with a rated voltage of 12 V

Page 1 of 5