If the oil leak from under the cylinder head cover could not be eliminated by tightening the cap fastening nuts, replace its gasket
In a variant, Chevrolet Niva cars can be equipped with a four-channel airbag system
During operation, the paintwork of the car acquires microscopic damage (scratches, chips, cracks, pores, etc.)
If a constant knock of valves is heard when the engine is idling, the hydraulic bearings of the drive levers are faulty. Replace defective hydraulic bearings
The controller is the central unit of the engine management system
You will need: a key "for 13", "for 19" (two), a beard, a hammer
Using a 13 wrench, unscrew the four nuts securing the intermediate shaft hinge housing to the flange of the transfer case drive shaft
The minimum allowable thickness of the friction linings of the brake pads is 1.5 mm. Replace pads in the following cases:
If the engine power drops, increased noise is heard, or periodic “howls” are heard during the operation of the fuel pump, then most likely the fuel pump is out of order
The main dimensions of the cylinder block are given in Figure 1.
Cylinder block cast from special low-alloy cast iron
The presence of a malfunction is signaled by the on-board diagnostic system by turning on the indicator
If oil leakage is detected from under the front crankshaft oil seal, it must be replaced
