Preparing the car for work. We install the car on a lift, disconnect the negative terminal of the battery.
Raise the car to a comfortable height.
Remove the front wheel from the side of the front fender removal
Replacing the CV joint covers of a car Lada Largus with a JH3 gearbox
We change the anthers of the drive hinges in case of damage or when replacing the hinge.
Preparing the car for repair. We perform work on a lift or on a viewing hole.
Brake pads must be replaced as a set
Preparing the car for work. We raise the car on a lift or hang the back of the car on a viewing hole.
How to replace the hydraulic valve compensators of the K4M engine
You will need: the same tools as for replacing the valve stem seals, with the exception of those that are needed directly to replace them (tools are used only for preparatory operations)
Removal of headlights, repeaters and taillights was discussed in the relevant articles
Replacing the tie rod end
The outer tip of the steering rod is replaced if play of the ball joint of the rod is detected or the ball joint cover is damaged
We remove the oil separator to clean it from deposits, as well as when dismantling the cylinder head cover
