Hydraulic pushers of the engine ZMZ-406, ZMZ-405, made in the form of cylindrical pushers and located between the camshaft and valves, combine two functions: transferring force from the camshaft to the valves and eliminating gaps in their drive

It is recommended to change the oil in the gearbox after 60 thousand kilometers of the car, and check the level every 20 thousand km

We replace the rear wheel pads in case of damage, oiling and wear of the pads to a thickness of less than 1 mm.

The drum is replaced if it is damaged, cracked, and the working surface is worn out up to a diameter of more than 283 mm. We replace all four rear wheel pads at the same time.

If the sensor fails, the engine starts poorly, especially after a long period of inactivity.

Poor throttle response, increased fuel consumption. Fault light on

Schemes of ZMZ-405 engine control systems may differ depending on which mass air flow sensor is installed

The piston of the 1st cylinder is set to the position of the top dead center (TDC) of the compression stroke so that when carrying out work related to the removal of the timing chains, the installation of the gas distribution phases is not disturbed