Over time, during operation, the gasket under the engine head cover loses its elasticity and strength and oil leaks from under the cover
You can try tightening the cover bolts.
If the oil leak from under the cylinder head cover could not be eliminated by tightening the cover bolts, replace its gasket.
You will need: a 12 wrench, a screwdriver.
Disconnect the wire from the negative terminal of the battery.
Drain the cooling system.
Loosen the inlet hose clamp and move it aside.
Disconnect the hose and wire harness holders.
Remove the crankshaft position sensor harness from the holder.
Remove the high voltage wire ends from the spark plugs.
If the replacement of high-voltage wires is not expected, the tips can not be removed from the wells of the cover
Loosen the ventilation hose clamp and remove the hose
Loosen the suction hose clamp and remove the hose
Disconnect the wire blocks from the primary connectors of the ignition coil.
Remove the head cover bolts...
Remove the cover along with the gasket, high voltage wires and ignition coils.
Inspect the condition of the valve cover seal and oil scraper tubes, replace if necessary
Remove the cover gasket.
Remove the gaskets for sealing the candle channels.
With a screwdriver, unscrew six screws and, prying with the same screwdriver, remove the oil deflector.
After washing all the parts in kerosene, wipe dry. Degrease the mating surfaces of the oil deflector and valve covers, as well as screws.
We apply glue-sealant to the oil deflector and, after setting it in place, press it tightly.
Wipe the surface of the cylinder head
Install a new gasket on the cover, install the cover in the reverse order of removal, and connect all hoses and wires