The clearances between the rocker arms and valves are adjusted on a cold engine, with the cylinder head fastening nuts and the nuts fastening the racks of the rocker arm axles are tightened to the required torque
On the ZMZ-402 engine, an ignition distributor sensor (1908.3706) is installed - contactless, with a sensor (generator) of control pulses and built-in vacuum and centrifugal ignition timing controllers
We remove the gearbox during partial or complete repairs, also when replacing the clutch mechanism
We work together on the inspection ditch
It is more convenient to work together
Remove the gearbox. We look at the article - "How to remove and install the gearbox of a Gazelle car".
- Removal and installation of the intermediate shaft of the ZMZ-406 engine
- Assembly description ZMZ-402
- Repair of the connecting rod and piston group ZMZ-402
- How to check and adjust the angles of the front wheels of a Gazelle car
- Replacing and adjusting the bearings of the rear wheels of a Gazelle car
- How to remove and install the hood and its lock of a Gazelle car
- Removing the rear wheels and axle shafts of the Gazelle car
- Checking and replacing the injectors of the Gazelle car engine
- Changing the oil and oil filter of a Gazelle car engine
- How to replace the hydraulic clutch hose of a Gazelle car
- Repair of the fuel module of the car Gazelle
- Replacing the Gazelle car drive belt
- Replacing the throttle cable of a Gazelle car
- Replacing the rear brake hose of a Gazelle car
- Removing and installing the throttle assembly of a Gazelle car
