The cardan gear consists of an intermediate cardan shaft, an intermediate support, a rear cardan shaft and three cardan joints
Schemes of ZMZ-405 engine control systems may differ depending on which mass air flow sensor is installed
Bleeding the power system
It is necessary to bleed the engine power system after replacing fuel filters and during other work related to the removal of parts of the power system, as well as when air enters the system
A car's air filter consists of a housing and a filter element
The air filter is installed on the right side of the engine compartment
- Adjusting the valve clearances of the ZMZ-402 engine
- Ignition timing adjustment ZMZ-402
- How to remove and install the gearbox of a Gazelle car
- How to disassemble and assemble the gearbox of a Gazelle car
- Removal and installation of the intermediate shaft of the ZMZ-406 engine
- Assembly description ZMZ-402
- Repair of the connecting rod and piston group ZMZ-402
- How to check and adjust the angles of the front wheels of a Gazelle car
- Replacing and adjusting the bearings of the rear wheels of a Gazelle car
- How to remove and install the hood and its lock of a Gazelle car
- Removing the rear wheels and axle shafts of the Gazelle car
- Checking and replacing the injectors of the Gazelle car engine
- Changing the oil and oil filter of a Gazelle car engine
- How to replace the hydraulic clutch hose of a Gazelle car
- Repair of the fuel module of the car Gazelle
