It is recommended to change the oil in the gearbox after 60 thousand kilometers of the car, and check the level every 20 thousand km
Pour 1.2 liters of gear oil into the gearbox.
You need to fill with SAE 75W-85 or 75W-90 gear oil.
For this work, you will need a 12 hex wrench, a container for draining oil, a syringe - a supercharger.
Drain the gearbox oil immediately after the trip, before it cools down.
We install the car on a lift or a viewing ditch.
Cleaning the breather from dirt
Use a 12" hex wrench to unscrew the drain plug
Drain the oil into a wide container with a volume of at least two liters
If the used oil is dark in color or metal particles are visible in it, we flush the gearbox, for which we install the drain plug in place, cleaning its magnet from steel chips.
Using a 12 hex wrench, unscrew the filler plug on the side of the crankcase.
Pour about one liter of a mixture of gear or engine oil with 20–30% kerosene or diesel fuel into the box with an oil syringe and replace the filler plug
Substituting stops under the front wheels, we hang out the rear wheel or the entire axle.
Having switched on the first gear, we start the engine for 2–3 minutes.
Having installed the car on the wheels, completely drain the flushing oil (draining time is at least 5 minutes).
Having cleaned the drain plug again, we wrap it with a key in place.
Having unscrewed the filler plug, fill the gearbox with fresh gear oil (1.2 l) with an oil syringe.
We wrap the filler plug in place.
