Design features of the brake master cylinder

The main brake cylinder, with two pistons 10 and 17 in series and a two-section reservoir 4 with a sensor 6 for an emergency drop in the brake fluid level, is attached to the cover of the vacuum booster

The car is equipped with a windshield wiper 60.5205 or 70.5205 with an electric drive for two brushes

The wiper motor with a gearbox and a system of drive levers is located in the engine compartment under the lower lining of the front end

Usually, the head gasket is replaced with the following damage:

  • - Gas breakthrough into the cooling system;

Before you begin troubleshooting any electrical circuit, carefully study the relevant diagram to understand its function as clearly as possible

  1. Removal and installation of the crankshaft ZMZ-402
  2. Adjustment of the steering mechanism with the hydraulic booster of the Gazelle car
  3. Repair and adjustment of the parking brake of a Gazelle car
  4. Checking the knock sensor ZMZ-406
  5. The procedure for assembling the ZMZ-405 engine
  6. Mass air flow sensor ZMZ 406
  7. Hydraulic chain tensioner ZMZ-406
  8. Repair of the rear doors of the Gazelle car van
  9. Purpose of the car fuses Gazelle
  10. Repair and replacement of the ZMZ-406 piston engine
  11. How to remove and install the cylinder head ZMZ - 402
  12. Replacing the nozzle of the ZMZ 406 engine
  13. Checking and replacing the brushes of the generator and the voltage regulator of the car Gazelle
  14. How to replace timing chains and gears ZMZ-405, ZMZ-406
  15. Checking and replacing the ignition coils of the ZMZ-406 engine

Page 38 of 45