The piston of the 1st cylinder is set to the position of the top dead center (TDC) of the compression stroke so that when carrying out work related to the removal of the timing chains, the installation of the gas distribution phases is not disturbed
On the ZMZ-402 engine, before removing the filter, drain the oil from it by unscrewing the plug
Unscrew the emergency oil pressure switch at the bottom of the filter
If the position of the front wheels corresponds to a straight-line movement, and the steering wheel spokes are not horizontal, this indicates a violation of the adjusting angles of the wheels, the presence of defects in the steering or suspension
Repair of the cylinder head is carried out during general engine repairs and when replacing the cylinder head gasket.
Design features of the brake master cylinder
The main brake cylinder, with two pistons 10 and 17 in series and a two-section reservoir 4 with a sensor 6 for an emergency drop in the brake fluid level, is attached to the cover of the vacuum booster
The car is equipped with a windshield wiper 60.5205 or 70.5205 with an electric drive for two brushes
The wiper motor with a gearbox and a system of drive levers is located in the engine compartment under the lower lining of the front end
