Usually, oil baffle caps are changed when there is increased oil consumption, accompanied by a large emission of smoke from the muffler

The crankshaft position (timing) sensor type (2612.1.113 BOSCH or 406.3847113) of the inductive type is designed to determine the angular position of the engine crankshaft, synchronize the operation of the controller with the engine's working process and determine the crankshaft speed.

After repairing the crankshaft, as well as the flywheel, clutch or pulley installed on it, it is necessary to balance them

The arrangement of the centrifugal oil filter is shown in fig. 1.

Washing parts of the centrifugal oil filter made of aluminum alloy is not allowed in an aggressive environment

Usually, the head gasket is replaced with the following damage:

• - Gas breakthrough into the cooling system;

You will need: a hex wrench “6”, heads “12”, “13”, “14”, a small chisel, a hammer

Drain the cooling system

K-151, K-151D carburetor adjustment

The fuel level in the float chamber is adjusted with the carburetor cover removed

Before assembly, each crankshaft must be checked on a magnetic or ultrasonic flaw detector for the absence of micro and macro cracks; as well as the compliance of the selected set of main bearing shells with the size of the main journals

When the ignition is switched on, the indicator lamp lights up (for 0.5 s) and goes out if the self-diagnosis system has not detected a malfunction

The damper is located inside the front of the block head on the left and attached to it from the outside with two bolts