We prepare the car and install it on a lift or a viewing ditch
Remove the engine mudguard, as described in the article "How to remove the decorative cover and mudguard of the 2AZ-FE Toyota Camry engine"
Disconnect the wire from the negative battery terminal
Remove mudguards and front wheel arch liners, for this
We unscrew the two screws securing the mudguard, remove the holders for attaching the mudguard to the body panel and remove it
In the same way, remove the mudguard on the other side
To remove the fender liner, remove the fender liner holders to the front bumper
We unscrew the bolts of the front fender liner to the body
We take out, the holders for fastening the fender liner to the front fender and remove the fender liner
After that, we proceed to remove the front bumper
The hood seal is attached to the front bumper holder with plastic clips
Press the latches and remove the caps securing the hood seal to the front bumper holder
We unscrew the bolt, unscrew the screws securing the front bumper holder and remove the hood seal and holder
We unscrew the two screws securing the front bumper to the amplifier
We unscrew one screw on each side of the bumper to the front fenders
Press the latches and disconnect the wire blocks from the fog lamp terminals
Remove the fog lamp washer hose from the holder
We unscrew the screws securing the fog lights to the bumper and remove them
Press the latch and disconnect the fog lamp washer hose from the reservoir pipe
Overcoming the resistance of the holders, remove the front bumper
Remove the energy-absorbing element from the front bumper amplifier
We unscrew three bolts on each side of the front bumper amplifier mount
Removing the bumper amplifier
Install all removed parts in reverse order
