Rack and pinion steering with hydraulic booster

When fixing the steering bracket in a vise, place copper plates on the jaws of the vise, put a rag or similar material under it

Mazda 3 automatic transmission shift mechanism

The switching unit consists of a lock cable, a lock cam and a lock mechanism.

Pull out the parking brake lever (fig. 1) several times.

Depress the brake pedal several times.

Removing and installing Mazda 3 front fender panel

Disconnect the negative battery cable

Disconnect the negative battery cable.

Remove the plug hole plate.

Remove the high voltage wire.

Checking sensor resistance

Disconnect the ABS wheel speed sensor connector

Replacing the transverse arm of the car's rear suspension

Performing the following procedures without first removing the anti-lock braking system wheel speed sensor may result in an open circuit in the wiring harness if the harness is taut by mistake

Checking and replacing the 1.6 engine idle speed controller

Preparing the car

Design and operation of the Mazda 3 transmission mechanism

The transmission mechanism (Fig. 1) consists of three pairs of clutches, a brake, a band brake, a one-way clutch and two pairs of single planetary gears

Remove the instrument cluster trim panel.

Remove the instrument cluster unit.

Remove the upper part of the dashboard.