Starter check and replacement

Make sure the battery is fully charged.

Crank the crankshaft with the starter and make sure that the starter runs evenly, without extraneous noise

The front suspension ( fig. 1 ) is equipped with McPherson struts.

The top end of each strut/spring assembly is attached to a custom car body panel

Снятие и установка главного цилиндра тормозов Mazda 3

Не допускайте попадания тормозной жидкости на окрашенные поверхности.

При попадании тормозной жидкости на окрашенную поверхность смойте ее немедленно

The windshield wiper system consists of a gearmotor, linkage, wiper arms with brushes and a switch

Checking and replacing the alternator on a Mazda 3 car

Vehicle test:

Check the voltage at the generator terminals

Removing, checking and installing Mazda 3 clutch

Remove the gearbox in the final drive unit.

Remove the cover of the clutch release fork.