We bleed the brake system when air gets into it or the brake circuits are depressurized, when brake cylinders, hoses, tubes, etc. are replaced, as well as when fluid is changed

Remove the door (how to remove the door, you can see the article - Removing and adjusting the sliding door)

Clutch fluid needs to be changed after 2 years

We pump the hydraulic drive when replacing the working fluid, as well as to remove air from the system that got into it during the repair or replacement of individual components

The main brake cylinder with a two-section reservoir and an emergency drop in brake fluid level sensor is attached to the vacuum booster

  1. Repair of an additional heater of the Gazelle car
  2. Car rolling bearings Gazelle
  3. Design and verification of the thermal valve for supplying engine oil ZMZ-405
  4. Checking the generator on a Gazelle car
  5. Electrical diagram GAZ-2705 with engines ZMZ-4025 and ZMZ-4026
  6. Removal and installation of a heater radiator for a Gazelle car
  7. Replacing the brake cylinder of the rear wheels of a Gazelle car
  8. Removing the heater valve and the additional heater pump of the Gazelle car
  9. Removing the front beam of the car Gazelle
  10. Air intake and exhaust system of the ZMZ-40524 engine
  11. Replacing the glass of the sliding door and sidewall of the Gazelle car
  12. Replacing the front brake hose of a Gazelle car
  13. Car steering maintenance Gazelle
  14. Gazelle car throttle actuator adjustment
  15. How to remove the steering gear of a Gazelle car

Page 8 of 45