The cardan gear consists of an intermediate cardan shaft, an intermediate support, a rear cardan shaft and three cardan joints

Four fuel injectors are installed in the intake pipes of the cylinders

We adjust the bearings every 20 thousand kilometers, as well as when there is increased play in them, changing the lubricant and replacing the bearings

Knock sensor (0261231046 Bosch or GT 305) piezoelectric type mounted on the engine block under the intake manifold of the fourth cylinder

You will need: a hex wrench “6”, heads “12”, “13”, “14”, a small chisel, a hammer

We replace the brake disc in case of cracks or severe scuffing on its surfaces, as well as when it is worn to a thickness of less than 19 mm.