The piston of the 1st cylinder is set to the position of the top dead center (TDC) of the compression stroke so that when carrying out work related to the removal of the timing chains, the installation of the gas distribution phases is not disturbed

In order to remove the fender, you must first remove the front turn signal, turn signal and remove the bumper

Clutch fluid needs to be changed after 2 years

We pump the hydraulic drive when replacing the working fluid, as well as to remove air from the system that got into it during the repair or replacement of individual components

Replacing the throttle cable of ZMZ-40522, ZMZ-40524, ZMZ-406 engines

Disconnect the negative battery terminal.

The head of the block can be removed with the intake pipe and exhaust manifold.

If the head of the block is removed from the engine installed on the car, you must first perform the following operations:

We adjust the bearings every 20 thousand kilometers, as well as when there is increased play in them, changing the lubricant and replacing the bearings