Checking the brake disc
Check for corrosion, wear and damage on the inner walls of the cylinder.
Replace cylinder body if necessary
Disassembling and assembling the compressor overrunning clutch
Disassemble in the order shown in Figure 1.
Remove the battery cover.
Disconnect the negative cable from the battery.
Remove the air filter
Снятие и установка главного цилиндра тормозов Mazda 3
Не допускайте попадания тормозной жидкости на окрашенные поверхности.
При попадании тормозной жидкости на окрашенную поверхность смойте ее немедленно
Removing and installing refrigerant lines (LF) Mazda 3
Disconnect the negative cable from the battery.
Discharge the coolant
Removing and installing rear wheel hub Mazda 3
Rear wheel hub components are shown in fig. 1.
Mazda 3 manual transmission assembly
Installation of individual components of the differential, as well as verification procedures, are given below
