Removing and installing the front bumper

Disconnect the negative battery cable

Starter check and replacement

Make sure the battery is fully charged.

Crank the crankshaft with the starter and make sure that the starter runs evenly, without extraneous noise

Consumers are connected to the "positive" power source by a wire, and to the "negative" one - through the car body ("mass"). This method allows you to reduce the number of wires and simplify installation

Disconnect the negative battery cable.

Remove the plug hole plate.

Remove the high voltage wire.

Replacing and checking the front shock strut Mazda 3

Remove the wheel speed sensor mounting bolt. Loosen the brake hose bracket bolt.

Remove the stabilizer bar nut and the lower shock absorber bolt

The vehicles are equipped with a hydraulic brake system.

Front disc brakes, rear disc or drum brakes