Removing and installing windshield washer motor

Disconnect the negative cable from the battery.

Remove the washer reservoir.

Drive shafts transmit torque from the engine, gearbox and differential to the front wheels

In the gearbox housing, the drive shafts are splined to the side gears of the differential

The windshield wiper system consists of a gearmotor, linkage, wiper arms with brushes and a switch

Remove

• ─ Remove the front cross member assembly.
• ─ Remove the anti-roll bar

The operation of the Anti-Lock Brake System (ABS/TCS) or DSC On-Board Diagnostics is essentially the same as the previous 323 (BJ), with the following exceptions:

• - diagnostic codes, PID data monitor functions and active commands functions have been changed;
• - removed TBS pin of DLC connector;

Checking the variable valve timing actuator (L3) Mazda 3

The actuator for changing the valve timing is a precision assembly and cannot be disassembled.

Disconnect the negative battery cable

A control pilot valve that directs fluid from the power steering pump to one side or the other of the steering rack piston

Car stability control system (cruise control) Mazda 3

The cruise control system allows you to set and automatically maintain a constant vehicle speed (but not less than 30 km/h)

Preparing the car

Wipe the top of the battery with a cloth dampened with a 10% solution of baking soda or ammonia, and then clean water

Mazda 3 Dynamic Stability Control DSC HU/CM

Using a compact and lightweight ruggedized DSC HU/CM integrated unit