The intermediate shaft drives the oil pump

Inlet and outlet rubber hoses fit to the heater core. Fluid is taken into the radiator with the heater valve open, from the cylinder head, and drained to the engine cooling system pump.

We replace the brake pads simultaneously on both front wheels of the car with a decrease in the lining thickness to 3 mm

Remove the steering column lining

Disconnect the wires from the brake light switch

Removing and installing the throttle assembly of the engine ZMZ-40522, ZMZ-406

Turn off the ignition, disconnect the "negative" terminal of the battery

Shock absorbers are used to dampen suspension vibrations

Protruding from the shock absorbers, the upper parts of the rods are protected from dirt by rubber caps.

Inspection, check and lubrication of the driveline

First of all, inspect the driveshafts and forks - cracks, dents or other deformations are unacceptable

A feature of the ZMZ-40524 engine ignition system is the presence of four separate ignition coils installed directly on the spark plugs, instead of two separately installed coils serving two engine cylinders each

The piston of the 1st cylinder is set to the position of the top dead center (TDC) of the compression stroke so that when carrying out work related to the removal of the timing chains, the installation of the gas distribution phases is not disturbed

Clean all mating surfaces of the block from gaskets stuck and torn during disassembly