• Home
  • Systems
    • Renault Logan
    • Toyota Camry
    • UAZ-Patriot
    • Niva VAZ-21213
    • Kia Magentis
    • Lada-Largus
    • Niva Chevrole
    • Mazda 3
  • VAZ
    • Gazelle
    • GAZ-3110
  • Search

Checking high-voltage wires ZMZ 406

High voltage wires are made of PV PPV wire with a diameter of 8 mm

How to set the TDC of the ZMZ-405, ZMZ-406 engine

The piston of the 1st cylinder is set to the position of the top dead center (TDC) of the compression stroke so that when carrying out work related to the removal of the timing chains, the installation of the gas distribution phases is not disturbed

Replacing the oil filter of the ZMZ-402 engine

On the ZMZ-402 engine, before removing the filter, drain the oil from it by unscrewing the plug

Unscrew the emergency oil pressure switch at the bottom of the filter

Replacement of the cylinder head gasket for the ZMZ-405, ZMZ-406 engine

Usually, the head gasket is replaced with the following damage:

  • - Gas breakthrough into the cooling system;

Mass air flow sensor ZMZ 405

Checking and replacing the air flow sensor ZMZ 405

Mass air flow sensor - thermopneumatic type IVKSH 407282000, installed in the intake system after the air filter

Hydraulic chain tensioner for engine ZMZ-406

Since the hydraulic tensioners keep the chains constantly taut, regardless of chain stretch or shoe wear, there is no need to adjust the chain tension during operation

Replacing the nozzle ZMZ 406

Relieve fuel pressure in the fuel system

Turn off the ignition and remove the "negative" terminal of the battery

Page 24 of 26

  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26

Select your language

  • Русский (Россия)
  • Español (España)
  • English (UK)
  • Қазақша (kk-KZ)
  • Deutsch (Deutschland)
  • Українська (Україна)
  • How to replace the timing chain of the 2AZ-FE Toyota Camry engine
  • How to replace the camshaft Niva Chevrolet
  • Front fender replacement in Mazda 3
  • Toyota Camry Sensor Failure Compensation
  • Replacing the upper arm on the Mazda 3