Renault map with remote control

The message "Insert card" appears on the on-board computer display

We remove the backstage for repair or to replace the transmission control cables

Checking and adjusting wheel alignment angles are necessary to ensure good vehicle stability and controllability, as well as even tire wear during operation

The speed limiter is a device that allows you to set the maximum speed

Removing the fuel pump module

Disconnect the wires from the battery terminals, starting with the negative terminal

Raise the rear seat cushion

For the stable operation of the injection engine in all modes, a constant fuel pressure in the fuel rail is required

Replacing the boot of the outer hinge of the front wheel drive shaft (F4R engine)

Remove the wheel drive shaft from the corresponding side

Removing the selector lever housing

Put the car on a two-post lift

Remove

Place the selector lever in the "N" position

Disconnect the wires from the battery terminals, starting with the negative terminal

The hydraulic block or hydraulic distributor, receiving signals from the electronic control unit, switches channels in the control valve block and controls the clutch engagement pressure