On some vehicle variants, a mechanical clutch is used

We install the gearbox on a special stand or workbench with the back cover up

Engines installed on Renault Megan 2 cars are equipped with an electronic engine management system with distributed fuel injection

Remove bracket

Put the car on a two-post lift

Automatic work

Vehicles are equipped with a lever switch with a ring for adjusting the frequency of the brushes in automatic mode or an automatic change in the frequency of brushes in intermittent mode

Heated oxygen sensors

Heated oxygen sensors are switched on by the ECU under the following conditions:

Removing the rear lights

Remove the rear light access cover from the luggage compartment

Displays on the display (see 1, fig.1.), located on the instrument panel (location depends on the vehicle equipment)

Preparing the car for work. We prepare the TORX T20 key, a screwdriver

This system provides controllability of the car in extreme conditions (avoidance of a collision with an obstacle, skidding in a turn, etc.)