You will need a soldering iron to replace the sensor

In a fuel supply system without a fuel return line to the tank, the fuel supply pressure does not depend on engine load

Put the car on a two-post lift

Make sure the vehicle springs and dampers are color-coded to match the parts

We remove the rear suspension beam in case of its deformation or when removing the entire rear suspension

We install the car on a lift or a viewing ditch

Renault Megane 2 is equipped with electric power steering.

Steering is adjustable for rake and reach

Replacing the boot of the outer hinge of the front wheel drive shaft (F4R engine)

Remove the wheel drive shaft from the corresponding side

Removing the heater core

Disconnect the wires from the battery terminals, starting with the negative terminal.

Automatic work

Vehicles are equipped with a lever switch with a ring for adjusting the frequency of the brushes in automatic mode or an automatic change in the frequency of brushes in intermittent mode

Brake fluid needs to be changed after 90 thousand km, or six years of car operation

Hold the multifunction switch lever in the end position (in the forced first gear position) with a plastic band and a bolt screwed into the gearbox housing (fig. 1)