Put the car on a two-post lift
Checking pad thickness. To do this, we raise the car, remove the wheels and look through the inspection hole in the cylinder body
The minimum thickness of the brake pads is 1mm. Wear limit 2.0 mm.
Putting the car on a lift.
Remove the rear wheels
Using the keys 13 and 15, unscrew the upper guide bracket
With the same keys, unscrew the lower bolt of the guide bracket
Remove the bracket
Removing pads
Using a puller, we recess the caliper piston
(if there is no puller, you can use the key to unscrew the discs of the grinder).
Using a tool or a key, turn the piston clockwise until it drowns.
Installing new pads
Replace the bracket
We tighten the bolts of the guides with a torque of 36 Nm
You can watch a video on replacing the rear pads:
We press the brake pedal several times to set the pistons to working condition.
Pull the parking brake handle several times to activate the parking brake system and the automatic brake pad wear compensation device.
We install the wheels and tighten the wheel bolts with a torque of 105 Nm.