Removing and installing Mazda 3 connecting shaft

The components of the front drive shaft are shown in fig. 1

Preliminary check of intermediate shaft

Check that the connecting shaft is not twisted or cracked

Removing and installing Mazda 3 condenser

Disconnect the negative cable from the battery.

Discharge the coolant.

Drain the engine coolant.

Removing and installing windshield washer motor

Disconnect the negative cable from the battery.

Remove the washer reservoir.

Disassembling and assembling the compressor overrunning clutch

Disassemble in the order shown in Figure 1.

Using pulse signals from the proximity switches on the Hall sensor in the power window motor, the power window control module in the power window main switch determines the position of the window and the direction of movement of the window

Checking the front door speaker

Check the resistance between the front door speaker leads.

If the resistance is not correct, replace the front door speaker

Checking the engine oil level

Make sure the vehicle is on level ground

Warm up the engine to normal operating temperature

Disconnect the negative battery cable.

Remove the plug hole plate.

Remove the high voltage wire.

Checking and replacing the alternator on a Mazda 3 car

Vehicle test:

Check the voltage at the generator terminals

In this article, we'll look at how to remove the steering wheel and driver's airbag