We remove the steering wheel to replace it, as well as when dismantling the steering column switch connector, steering column or instrument panel

Preparing the car for work.

Disconnect the negative battery terminal.

Using a Torx T20 screwdriver, unscrew screw 1, figure 1, fastening the inner handle 2 to open the door on the left or right.

How to replace the hydraulic valve compensators of the K4M engine

You will need: the same tools as for replacing the valve stem seals, with the exception of those that are needed directly to replace them (tools are used only for preparatory operations)

Replaceable element of the engine air filter is replaced at the next maintenance after 15 thousand kilometers

A condenser (air conditioning radiator) of a multi-flow type is installed in front of the radiator of the engine cooling system

Preparing the car for work. Remove the negative terminal from the battery.

Remove the intake silencer.

Remove the air filter housing.

We remove the clutch discs when they are worn out and when replacing the rear oil seal of the crankshaft and flywheel, as well as when repairing the engine

We remove the wiper if the electric motor and gearbox fail or when repairing the wiper trapezoid.

Prepare the car for the job. Disconnect the negative terminal of the battery.

We remove the wiper and repair it if the wiper motor or trapezoid fails

We replace the crankshaft oil seals when the engine is completely overhauled or if there is oil leakage in the oil seal area