Brake pads must be replaced as a set

Preparing the car for work. We raise the car on a lift or hang the back of the car on a viewing hole.

The air conditioning compressor is used to circulate the refrigerant in the system

Replacing the CV joint covers of a car Lada Largus with a JH3 gearbox

We change the anthers of the drive hinges in case of damage or when replacing the hinge.

Preparing the car for repair. We perform work on a lift or on a viewing hole.

Design of wheel drives with JH3 gearbox of a car Lada Largus

A design feature of the transmission with the JH3 gearbox is the equal length approximation of the drives

We remove the steering gear for repair or to replace steering rods or protective covers and the steering gear itself

The compressor pulley is mounted on a double-row ball bearing.

When pressing out, the bearing is destroyed, so we press it out only for replacement

We remove the springs when they break, sag, replace the spring gaskets, remove the beam and when removing the exhaust system (you have to remove the left spring)

We carry out the instrument cluster when replacing or repairing the instrument cluster, as well as when removing the instrument panel

It is advisable to check the liquid level in the expansion tank of the cooling system at each inspection of the car before leaving, and always in case of overheating of the engine and the associated release of liquid from the system

The clutch of the car Lada Largus is single-disk, dry type.