Solenoid nozzle (0280150560В or ZMZ DEKA IA9Z61) - an electromechanical valve that works on the principle of an electromagnet

The Gazelle car heater consists of a plastic casing in which a radiator is installed, two fans mounted on the motor shaft, upper, central and lower dampers and a control panel with three levers and switches

Before disconnecting hoses and electrical wires, it is recommended to mark them so as not to confuse them during assembly

The water pump is a centrifugal type, with an electromagnetic fan drive clutch, mounted on the chain cover, the coolant is supplied by the pump to the cylinder block

The main brake cylinder with a two-section reservoir and an emergency drop in brake fluid level sensor is attached to the vacuum booster

The pressure regulator is attached to the left side member of the frame

Drain the engine oil

Drain the engine coolant and remove the radiator.

Disconnect the intake pipes from the exhaust manifold

Adjustment of the steering mechanism is needed when the car's directional stability is low at high speed (you don't feel the steering wheel at high speed)

The car is equipped with two rectangular headlights with a AKG12-60+55-1 double-filament halogen lamp, 55/60 W (low/high beam) and a 4 W side light A12

The ignition distributor with a built-in Hall sensor produces voltage pulses, which the switch converts into current pulses in the primary winding of the ignition coil