Vehicle Stability Control helps provide comprehensive control of systems such as anti-lock braking system, traction control system, engine management system, etc.
In the article, we will consider the replacement of lamps in headlights, lanterns and ceiling lamps. Lamps are replaced if they are dim or the filaments are burned out
The electronic engine control system consists of sensors for engine and vehicle condition parameters, a controller and actuators
Removing the front wheel brake pads
When replacing brake pads, always change the inner pads, outer pads and pad covers as a set
Remove the master brake cylinder reservoir for flushing, remove the brake master cylinder for replacement in case of failure
We remove car lighting devices for repair, as well as for replacement
Before replacing lighting fixtures, disconnect the negative battery terminal
We set the piston of the first cylinder to the TDC position of the compression stroke so that when carrying out work related to the removal of the camshaft drive belt, the valve timing is not disturbed
Removing and installing the starter (models with 1-2AZ-FE engine)
Disconnect the wires from the battery terminals
Drain the coolant from the cylinder block and radiator
Adjusting the parking brake actuator
To check the correct adjustment of the parking brake drive, press the parking brake pedal all the way - you should hear about 7-8 clicks of the ratchet device