Disassemble the rear disc brake in the order described in the previous article

Hang up the caliper without disassembling it and secure it with wire

Mount the generator cover from the drive side to the rotor

Install washer

The fuel module is removed to replace the elements of the fuel module, as well as when replacing the fuel tank

Power supply circuits of electrical equipment are protected by fuses

Powerful current consumers are connected via relays

Checking the voltage regulator relay

Using an ohmmeter, check the continuity between diodes F and B (fig. 1)

Exhaust gases are removed from the engine through a catolector (exhaust manifold combined with a converter), an additional converter built into the exhaust pipe, an additional and main muffler

In the article, we will consider disassembly, assembly and verification of generator parts

We remove the generator from the car, as described in the previous article

We set the piston of the first cylinder to the TDC position of the compression stroke so that when carrying out work related to the removal of the camshaft drive belt, the valve timing is not disturbed

Drain the coolant from the cylinder block and radiator

The engine cooling system is liquid, closed type, with forced circulation of the liquid.

The device of the cooling system is shown in the figure