Put the car on a lift
Disconnect the battery
Remove the engine top cover and air intake grille.
Unscrew the two mounting bolts and the air filter access panel, as well as the bolts securing the wall of the air intake niche (Fig. 1).
Unscrew the air intake mounting bolts (fig. 2).
Remove the wall of the air intake niche.
Remove the battery.
Remove the battery tray.
Remove the air filter housing.
Remove the brake fluid from the reservoir with a syringe so that its level is below the fluid supply hole to the master cylinder.
Pull up the latch (fig. 3).
Pull the hydraulic clutch line out of the fitting by one click.
Place a rag under the air vent.
Depress the clutch pedal by hand to remove fluid from the master cylinder and tube.
Pull up the latch (see fig. 3).
Disconnect the pipeline from the working cylinder.
Insert plugs into the holes.
Press the latch with your hand while pulling out the pipeline (Fig. 4).
Do not pull on the latch. In case of any erroneous action, it is necessary to replace the pipeline.
Pull the hydraulic clutch line out of the fitting by one click.
Place a rag under the air vent.
Press the pedal by hand to remove fluid from the master cylinder and piping.
Press the lock.
Disconnect the pipeline from the working cylinder.
Insert plugs into the holes.
Install
Check the condition of the gaskets.
Installation is performed in the reverse order of removal.
Bleed air from hydraulic clutch.
Check clutch operation.
Connect the battery.
