The main cylinder is replaced with the following faults:

  • - incomplete release of all wheels (jamming of the master cylinder piston);

If during the next maintenance or when replacing a wheel it turned out that the wear of the pads exceeded the norms indicated in the table, then you need to change the pads.

Replace the hub bearing when play appears.

Bearing wear can be identified by increased noise when the vehicle is moving

On vehicles without ABS, a rear brake pressure regulator is installed

How to replace the hydraulic valve compensators of the K4M engine

You will need: the same tools as for replacing the valve stem seals, with the exception of those that are needed directly to replace them (tools are used only for preparatory operations)

Design of wheel drives with JH3 gearbox of a car Lada Largus

A design feature of the transmission with the JH3 gearbox is the equal length approximation of the drives

Page 9 of 16

New

Dismantling the driveline and replacing the crosspieces of the Gazelle car

Removal and inspection of the driveline was discussed in the article - “Inspection and removal of the cardan shaft of the Gazelle car”

Malfunctions of the cardan shaft are discussed in the article - “Design Features of the Cardan Drive of a Gazelle Car”

Replacing the muffler and resonator of a Gazelle car

We replace the muffler and resonator in case of burnout, through corrosion or mechanical damage