You will need: a pipe (gas) wrench, a screwdriver, a chisel, a beard, a hammer, a cross-piece remover, a snap ring remover, a metal brush, penetrating lubricant (for example, WD-40)

If during operation there are traces of brake fluid leakage on the brake drum and the inner side of the wheel, replace the slave cylinder

Two types of fog lamps are installed on the car, depending on the configuration

In a variant, ABS brakes are installed on the car

External signs of the need to remove bearings for troubleshooting are:

• – increased noise during wheel rotation;

The controller is the central unit of the engine management system

Replace the fluid in the power steering system if it is excessively contaminated

The manufacturer does not give clear recommendations on the frequency of changing the fluid in the hydraulic system, so we recommend replacing it after six years, regardless of condition

The vehicle is equipped with heater 12 (Fig. 1) of liquid type, combined with the engine cooling system. The heater radiator 1 (Fig. 2) is placed in a plastic casing installed in the central part of the instrument panel

On cars, in some trim levels, it is possible to install an electromechanical power steering

In the fuel injection system of the engine, the pressure is 30 MPa (3 kgf / cm ²).

Therefore, it is forbidden to loosen the fuel line connections while the engine is running or immediately after it has stopped.