We remove cardan gears for repair or when removing gearboxes and gearboxes

You will need: a pipe (gas) wrench, a screwdriver, a chisel, a beard, a hammer, a cross-piece remover, a snap ring remover, a metal brush, penetrating lubricant (for example, WD-40)

Signs of a throttle that is not fully closing can be increased idle speed and fuel consumption

To improve the appearance of the engine compartment, and to reduce noise from the engine, a decorative plastic casing (screen) is installed

According to the service book, the oil in the transfer case must be changed every 45,000 km

The ignition system uses a 4-pin ignition coil, which is a block of two 2-pin ignition coils

The mechanical parking brake acts on the brakes on the rear wheels

The windshield wiper kit consists of a wiper drive, levers and brushes

Scheme for turning on the cleaner is shown in fig. 1.

The crankcase ventilation system ensures the removal of crankcase gases.

Blow-by gases through the exhaust hose enter the oil separator located on the cylinder block

If checking the hinge reveals the need to replace it, replace it