Replacing the bearing and oil seal of the housing of the internal joint of the drive and the bracket for fastening the front axle Niva Chevrolet

Let's consider replacing the right wheel bearing

Removing the front wheel drive (For removing and installing the front drive, see the article - "Removing and installing the front drive")

Using pliers, remove the retaining ring

Removing the spring washer

We knock the bearing cover off the shaft, together with the bearing, using a hammer with a plastic head

Remove the inner joint housing bearing

Remove the adjusting ring from the groove with pliers

Remove the bearing cover with the stuffing box

If you need to replace the front axle mounting bracket, then remove it

We knock out the gland with a suitable head or a piece of pipe

Remove the gland from the cover

Lubricate the surface of the new oil seal, press it into the cover

The nodes are assembled in the reverse order.