Put the car on a level surface, jack it up and lower it onto stands.
Drain the gearbox oil (see Mazda 3 gearbox oil change).
It is recommended to change the engine oil together with the oil filter
Put the car on a level surface
Adjusting the AT mode selector cable
If during the operation of the car there is a discrepancy between the positions of the selector and the actual mode of operation of the automatic transmission, for example:
Removing and installing selector lever Mazda 3
The mechanism for shifting an automatic transmission is shown in fig. 1
Remove
- ─ Remove the front cross member assembly.
- ─ Remove the anti-roll bar
Consumers are connected to the "positive" power source by a wire, and to the "negative" one - through the car body ("mass"). This method allows you to reduce the number of wires and simplify installation
Checking and replacing the alternator on a Mazda 3 car
Vehicle test:
Check the voltage at the generator terminals
Replacing and checking the front shock strut Mazda 3
Remove the wheel speed sensor mounting bolt. Loosen the brake hose bracket bolt.
Remove the stabilizer bar nut and the lower shock absorber bolt
Disconnect the negative battery cable.
Remove the plug hole plate.
Remove the high voltage wire.
Checking the clearance in the front wheel bearing
- - Remove the front wheel.
- - Disconnect front left disc brake caliper.
