Design of wheel drives with JH3 gearbox of a car Lada Largus

A design feature of the transmission with the JH3 gearbox is the equal length approximation of the drives

The compressor pulley is mounted on a double-row ball bearing.

When pressing out, the bearing is destroyed, so we press it out only for replacement

Installing and preparing the car for work

Remove the negative battery terminal

A condenser (air conditioning radiator) of a multi-flow type is installed in front of the radiator of the engine cooling system

We remove the clutch discs when they are worn out and when replacing the rear oil seal of the crankshaft and flywheel, as well as when repairing the engine

This article describes the diagnostic procedure used for the electronic control unit (ECU) EMS 31.32 electronic engine management system (ECM) K7M and K4M