We remove the clutch discs when they are worn out and when replacing the rear oil seal of the crankshaft and flywheel, as well as when repairing the engine
Failure of the timing belt (timing) (breakage or shearing of teeth) will lead to the impact of the valves on the pistons due to the misalignment of the angles of rotation of the crankshaft and camshafts and, as a result, to costly engine repairs
Replacing the tie rod end
The outer tip of the steering rod is replaced if play of the ball joint of the rod is detected or the ball joint cover is damaged
Preparing the car for work.
Disconnect the negative battery terminal.
Using a Torx T20 screwdriver, unscrew screw 1, figure 1, fastening the inner handle 2 to open the door on the left or right.
We replace shock absorbers in case of fluid leakage from shock absorbers, loss of performance and the presence of obvious defects
How to remove the steering column switch Lada Largus
We remove the steering column switches for replacement, as well as when removing the steering column and instrument panel
Prepare the car for the job. Disconnect the negative cable from the battery
Disassemble the passenger compartment to remove the windshield glass:
Usually the heater is removed to replace the evaporator or to repair the heater
Preparing the car for work. We install the car on a lift, disconnect the negative terminal of the battery.
Raise the car to a comfortable height.
Remove the front wheel from the side of the front fender removal
Brake pads must be replaced as a set
Preparing the car for work. We raise the car on a lift or hang the back of the car on a viewing hole.
We remove the power steering pump for replacement, as well as when dismantling the engine