To work, you will need tools: TORX T40 wrench, 18 socket, screwdriver
Removing the front seats
We prepare the car, remove the negative battery terminal.
We unscrew the two screws of the rear fastening of the slide to the base of the body
We unscrew the two screws of the front fastening of the slide to the body
Pull out the retainer for fastening the wire block
Disconnect the harness connector of the seat belt buckle sensor
Press out the latch
Removing the seat belt buckle
Raise the seat and remove it from the passenger compartment
Install the front seat in reverse order
Removing and installing the rear seat
We press the latches of the seat cushion locks, lift the front of the cushion, and remove the cushion
Remove the seat cushion from the car.
Flip back the rear seat armrest and hatch cover
Unscrew the right seat bolt
We unscrew the two left bolts of the backrest.
Folding the rear seatback
Unscrew the bolt securing the left side of the backrest from the side of the trunk
Unscrew the bolt securing the right side of the backrest from the side of the trunk
Raise the backrest up and take it out of the car
Install the seats in reverse order.
