We remove the clutch discs when they are worn out and when replacing the rear oil seal of the crankshaft and flywheel, as well as when repairing the engine

This article describes the diagnostic procedure used for the electronic control unit (ECU) EMS 31.32 electronic engine management system (ECM) K7M and K4M

Preparing the car for work. We install the car on a lift, disconnect the negative terminal of the battery.

Raise the car to a comfortable height.

Remove the front wheel from the side of the front fender removal

We remove the power steering pump for replacement, as well as when dismantling the engine

Replacing the CV joint covers of a car Lada Largus with a JH3 gearbox

We change the anthers of the drive hinges in case of damage or when replacing the hinge.

Preparing the car for repair. We perform work on a lift or on a viewing hole.

Remove the front wheel drive to replace the drive covers.

We also remove it when replacing the drive seals and when dismantling the gearbox