Removing and disassembling the piston group

Remove the cylinder head.

Remove the crankcase and crankcase gasket

The head of the block can be removed with the intake pipe and exhaust manifold.

If the head of the block is removed from the engine installed on the car, you must first perform the following operations:

Relieve fuel pressure in the fuel system

Turn off the ignition and remove the "negative" terminal of the battery

Checking and replacing brushes and a voltage regulator on cars with an engine of the ZMZ-405, ZMZ-406 type

On engines of the ZMZ-406 and ZMZ-405 families, generators 9422.3701 or 5122.3771 with built-in integrated voltage regulators are installed.

You will need: a hex wrench “6”, heads “12”, “13”, “14”, a small chisel, a hammer

The electronic unit, processing the data received from the sensors of the system, controls the operation of two ignition coils, applying low voltage pulses to them