We remove the glove box when removing the instrument panel, and also when it is necessary to provide access to the controller and fuses of the engine management system
We also shoot during other body work.
Opening the lid of the glove box.
We slightly raise it and remove the cords that hold the lid from the slot on both sides
Use a Phillips screwdriver to unscrew the self-tapping screw, which is located on the side
With the same screwdriver, unscrew the two screws securing the instrument panel console
We unscrew the two screws from the bottom of the box, fastening it to the dashboard console
Opening the lid of the box.
On the left side, we unscrew the two self-tapping screws of the side fastening of the box body to the instrument panel console
Unscrew the screw of the upper left mount
We unscrew the screw of the upper middle fastening of the glove box body
On the right side, we turn off two self-tapping screws for fastening the lining of the box
Remove the lining from the box body.
On the right side, unscrew the screw of the upper fastening of the box body
Now you need to use a short screwdriver.
We unscrew the two screws of the bottom fastening of the box body
Tilt the box and disconnect the wire blocks from the terminals of the glove box light switch
We also disconnect the wires from the lighting lamp itself
Remove the glove box
Install all parts in reverse order
