Dashboard
The location of instruments and signaling devices in the instrument cluster is shown in the figure
The following devices and warning devices are installed in the instrument cluster.
- 1 - tachometer shows the engine speed. The scale has divisions from 0 to 7. The division value is 0.1.
In order to find out the crankshaft speed in min -1, you need to multiply the tachometer readings by 1000.
Red zone - a dangerous mode for the engine.
- 2 - signaling device for the ESP motion stabilization system and the ASR traction control system.
The blinking of the signaling device indicates the activation of the skid prevention mechanism or the deactivation of the traction control system.
The constant burning of the indicator indicates a malfunction of the systems.
- 3 - the engine management system malfunction indicator lights up when the ignition is turned on and goes out after the engine is started.
NOTE
When the warning light comes on when the engine is running, it indicates a malfunction of the engine control system.
This does not mean that the engine must be stopped immediately: the engine management system switches to emergency modes, allowing the engine to operate in conditions close to normal.
The cause of the malfunction should be eliminated as soon as possible, since prolonged operation of the car with the indicator on can lead to an increase in fuel consumption, deterioration in the traction characteristics of the car and engine breakdowns.
- 4 - the signaling device for turning on the left direction indicator lights up with a flashing light when the left direction indicator is turned on (synchronously with it).
Blinking of the signaling device at a double frequency indicates a burnout of a lamp in any left turn indicator.
If the indicator does not light up or stays on, this indicates a malfunction in the electrical circuits of the direction indicators.
- 5 - signaling device for the status of the anti-lock braking system (ABS).
The warning light comes on when the ignition is turned on, it goes out after the engine is started.
When the warning light comes on when the engine is running, it indicates a malfunction of the anti-lock braking system.
- 6 - the airbag status indicator lights up when the ignition is turned on and goes out after the engine is started.
If the warning light comes on when the engine is running or does not come on when the engine is started, it indicates a malfunction in the airbag system.
- 7 - on-board computer
- 8 - open door alarm.
Illumination of the warning lamp indicates that the side doors or the trunk lid are open or not closed tightly.
- 9 - the preheating mode indicator (only on vehicles with a diesel engine) lights up when the ignition is turned on.
The warning lamp goes out when the glow plugs reach the required temperature - the engine is ready to start.
- 10 - the signaling device for turning on the right direction indicator lights up with a flashing light when the right direction indicator is turned on (synchronously with it).
Blinking of the signaling device at a double frequency indicates a burnout of the lamp in any right turn indicator.
If the indicator does not light up or stays on, this indicates a malfunction in the electrical circuits of the direction indicators.
- 11 - the engine oil pressure warning light comes on when the ignition is turned on, and the warning light goes out after a few seconds.
If the warning light stays on or comes on while the engine is running, the oil pressure is low.
- 12 - the battery discharge indicator lights up when the ignition is turned on and goes out after the engine is started.
If the indicator does not go out or lights up while the engine is running, this indicates an increase or decrease in the battery charging current.
- 13 - an induction type speedometer shows how fast the car is currently moving.
The scale is graduated from 0 to 250, the division value is 10 km/h.
- 14 - indicator of cruise control system modes.
- 15 - the signaling device for the parking brake and the emergency state of the brake system lights up when the ignition is turned on and goes out after the engine is started.
The constant burning of the indicator with the ignition on may indicate that the parking brake is on or the brake fluid level has dropped below the “min” mark on the brake master cylinder reservoir.
- 16 - fuel gauge.
Moving the fuel level arrow to the front zone indicates the need for refueling in order to avoid interruptions in engine operation.
- 17 - particulate filter status indicator (on vehicles equipped with a diesel engine) lights up when the particulate filter is dirty.
- 18 - indicator of the minimum fuel reserve in the tank.
- 19 - signaling device for the state of the liquefied petroleum gas supply system.
- 20 - the emergency stop indicator lights up when the ignition is turned on and goes out after the engine is started.
If the warning light comes on while driving, stop immediately and turn off the engine.
- 21 - indicator of the state of the engine start blocking system.
- 22 - the maintenance indicator lights up when the ignition is turned on and goes out when the engine is started.
- 23 - signaling device for turning on the fog lights.
- 24 - signaling device for turning on the rear fog lights.
- 25 - coolant temperature gauge.
If the pointer approaches zone "A", the engine has overheated. You should stop, let the engine cool down and eliminate the cause of the engine overheating.
WARNING
Do not operate the vehicle with an overheated engine, as this will cause serious engine damage.
- 26 - signaling device for switching on the dipped headlights.
- 27 - signaling device for high beam headlights.
On-board computer
The on-board computer is an information system that displays trip information and information messages.
Press the toggle button for trip information.
To reset the reading, press and hold the key.
The following trip information can be displayed on the trip computer display
Counter of total A and daily mileage B.
- carburant - the amount of fuel consumed since the last reset.
- moynne - average fuel consumption since the last reset.
- instantanne - the current fuel consumption displayed on the display after the vehicle reaches a speed of 30 km/h.
- autonomie - power reserve on the remaining fuel in the tank.
The range calculation takes into account fuel consumption since the last reset.
The value is shown on the display after the vehicle has traveled 400 m.
- distance - the distance traveled since the last reset.
- moyenne - average speed since last reset.
The value is shown on the display after the vehicle has traveled 400 m.
- vidange dans - mileage until the upcoming oil change, maintenance.
Reset mileage to upcoming oil change/maintenance only after maintenance.
- regulateur, limiteur - cruise control speed setpoint.
- pas de message memorise - logbook, informational messages are displayed.
The on-board computer display may show the following No informational messages.
- inserer la carte - insert the card key into the reader.
- niveau huile correct - oil level is correct.
- eclairage auto des feux off - automatic switching on of lights is turned off.
- esp/asr des active - disable the stabilization system and traction control.
- capteurs pneus absent - the tire pressure sensor is missing or defective.
- pression pneus a reajuster - adjust the air pressure in the tires.
