To remove the lining of the floor tunnel, you will need a TORX T20 key, screwdrivers, side cutters.
Disconnect the negative battery terminal
We unscrew the two screws securing the rear of the cladding on the right and left
Pry off the edges of the frame of the gearbox control lever cover with a screwdriver at the locations of its latches
Removing the frame
We bite with side cutters the clamp that secures the cover to the gear lever
Remove the cover of the gear lever
Pry off the cover of the parking brake adjusting unit with a screwdriver
Disconnect the wire blocks from the switches
Remove the cover
Pry off the top trim with a screwdriver
Let the upper lining of the floor tunnel up to the length of the wiring harness
Press the latch of the cigarette lighter socket
Disconnect the block from the cigarette lighter socket
We unscrew the two front screws securing the lining of the floor tunnel
Removing the lining.
Install the cladding in reverse order.
