We disassemble the generator to replace and repair parts of the generator

Remove the nut and remove the lead insulator

In the article, we will consider the removal, repair and installation of the clutch master cylinder of a car

The engine cooling system is liquid, closed type, with forced circulation of the liquid.

The device of the cooling system is shown in the figure

If the car won't start

Simple checks

Before checking, be sure to perform the starting procedure and make sure that there is enough fuel

The electronic engine control system consists of sensors for engine and vehicle condition parameters, a controller and actuators

The front suspension is independent, McPherson linkage spring type, with telescopic shock absorber struts, coil springs, lower wishbones and anti-roll bar

Disassemble the rear disc brake in the order described in the previous article

Hang up the caliper without disassembling it and secure it with wire

Drain the coolant from the cylinder block and radiator

Vehicles equipped with a hydraulic brake system

Remove the fuel rail and injectors for flushing or replacement