Preparing the car for work.
Remove the negative battery terminal.
To complete the task, you will need tools: a set of screwdrivers, a head of 8.
Using a Phillips screwdriver, we unscrew the self-tapping screw for fastening the lining of the inner handle
Remove handle cover
Squeeze the latch tabs
And remove the door lock button
Insert a screwdriver between the socket and the trim of the window handle
Moving the handle lining
Removing the cladding
Remove the window handle
Remove the outlet
Using a Phillips screwdriver, unscrew the fastening screw of the upholstery installed in the niche of the armrest
Using a Phillips screwdriver, unscrew the two screws securing the upholstery from below
We remove the lower part of the upholstery, removing the six clips of its fastening from the holes in the door panel
Remove the door upholstery
Removing the outside rear door handle
Remove the upholstery of the rear door, as mentioned above.
Unscrew the bolt with an 8 head
Remove the rear glass guide
Pry off with a screwdriver, disconnectm from the lock lever pull the outer handle
With a head of 8, unscrew the nut securing the outer handle
Unscrew the outer handle bolt
Slide forward all the way and lifting the handle, take it out of the door together with the rod
Install the outer rear door handle in reverse order.
Removing the rear door lock
Remove the door upholstery as described above.
Disconnect the outer handle rod from the lock lever.
Disconnect the block of wires of the electric drive of the lock and the block of wires of the door
Disconnect the wiring blocks of the interior light switch (the switch is in the lock)
Remove the spacer sleeve from the window lifter axis
Use a Phillips screwdriver to unscrew the two screws
Remove the upholstery mounting bracket
Peel off the protective film
Squeezing the latch with pliers, disconnect the rod from the inner door handle
Remove the rod of the inner handle from the holder
Remove the lock button insert from the lock
Using a Phillips screwdriver, unscrew the screw securing the lock release drive housing
Sliding the drive housing down, remove the housing and remove the rod from the holder
Use a Phillips screwdriver to unscrew the three screws securing the lock to the door
Remove the lock assembly with rods and electric drive
Install the lock in reverse order.
Removing and installing the rear door window regulator
Remove the upholstery as described above
Disconnect the rod of the inner handle and the lock of the lock
We fix the glass in the raised position (you can use a screwdriver)
We unscrew the bolts of the sliding glass mounting plate
We unscrew the two central nuts of the power window
Unscrew the upper window nut
Unscrew the lower window nut
Remove the power window assembly through the service hole
Install the power window in reverse order.
Lubricate the parts of the window regulator with Litol-24 grease or an equivalent.
Replacing the tailgate sliding glass
Remove the door upholstery as described above
Remove the power window.
We unscrew the bolt of the sliding glass guide and remove the guide
Remove the lower glass seal
Remove the upper glass seal
Turn the glass in the window opening, as shown in the photo
Removing the glass from the opening
Install glass in reverse order
Removing and installing the rear door
Disconnect the negative terminal from the battery
Unscrew the bolt securing the door opening limiter to the body
Remove the rubber protective tube of the wires from the B-pillar
Holding the wires, pull the wire connector out of the rack and disconnect it
Remove the locking brackets of the hinge axes (old version)
With a head of 8, we unscrew the two locking bolts of the hinges (new version)
Remove the door upwards
Install the back door and all parts in reverse order
