Relieve fuel pressure in the fuel system
Turn off the ignition and remove the "negative" terminal of the battery
Disconnect the auxiliary air regulator connector.
Remove the air supply hose and disconnect the throttle cable from the throttle body.
Use a screwdriver to loosen the clamp of the lower (outlet) hose of the idle speed regulator.
Using a screwdriver, loosening the clamp, remove the hose of the crankcase ventilation system.
Loosen the clamp, remove the vacuum brake booster hose.
Using a screwdriver, loosening the clamp, remove the fuel pressure regulator hose
Using the “13” key, unscrew the nut that secures the tip of the “ground” wire to the first intake manifold stud
Similarly, disconnect the wire from the last intake manifold stud.
Then, having unscrewed the remaining nuts of the intake manifold studs with the “13” wrench, remove the receiver.
Loosening the clamp, remove the supply hose from the fuel rail fitting.
Loosen the clamp, remove the crankcase ventilation hose from the idle system pipe.
Loosen the clamp and remove the drain hose from the fuel pressure regulator fitting.
Using the “10” key, unscrew the two bolts securing the fuel rail to the intake manifold and remove the rail
Prying off the spring latch of the block with an awl, disconnect the connector from the nozzle.
Remove the nozzle from the manifold.
Install the nozzle in reverse order.